Assembly Instructions for Dream Booth!

STEP 1: BASE

SORT all of the plastic parts with RED DOTS

  • Assemble them into the base.

base1

  • Make sure the longer pole is in the back.
  • Add vertical poles with rings on them to front Ls.
  • Add vertical poles without rings on back corners.
  • Make sure UP ARROWS are facing up.

STEP 2: MID LEVEL

FIND all of the remaining plastic parts with BLUE DOTS

  • Add them to create the middle level
  • Place a T on the to of each vertical. 
  • Connect the sides.
  • Add the two short poles to the back Ts.
  • Connect the back.
20181229_171217a

SIDE

20181229_171146a

BACK

  • Connect vertical poles with rings to the front Ts.
  • Connect vertical poles without rings to the back Ts.
  • Make sure the UP ARROWS face up.

STEP 3: TOP LEVEL

FIND all of the remaining plastic parts with GREEN DOTS

  • Place a corner on the top of each vertical pole.
  • Connect the sides.
  • Connect the back. 

 

STEP 4: ADD BANNERS

USE CLIPS TO ATTACH BANNER LINES ALONG OUTSIDE

  • Use clips to loop a Dreamline to one of the front poles. Fold over and clip with binder clip.
  • Loop Dreamline around back of back poles, above the Zip Tie (holds it up).
  • Attach to the other front pole in the same way and tighten.

20181229_171616a

 

 

STEP 5: ADD HEADER

USE VELCRO TO ATTACH THE HEADER

  1. Header is the long piece of cloth.
  2. Attach that to the right front pole first. Make sure the Project Information Card is facing rig side up.
  3. Work your way around. (Lights not included.)

20181206_1918073255907964381294609.jpg